Ingenico Lane/3000 - Device Disconnected

Ingenico Lane/3000 - Device Disconnected

Step By Step:

Step 1: Verify that you are using the provided multi-point mono connector (Ethernet) cable and power supply. The power supply plugs into the splitter on the Ingenico multi-point mono connector cable.

Step 2: Verify that the Ethernet jack on the multi-point mono connector cable is plugged securely into your router, modem, networking switch, or Ethernet wall jack.

Step 3: Verify that your device was obtained from the CardPointe shop, or your software provider.

Step 4: Consult with your IT administrator to verify that the Ethernet port being used has access to the Internet, and that your internal network allows CardPointe Integrated Terminal connections. This will ensure that a firewall is not blocking the connection.

    • Related Articles

    • Ingenico Lane/3000 User Guide

      Article Contents: This Ingenico Lane/3000 User Guide covers the device's features, setup process, and troubleshooting. It explains how to connect the device, enter text using the multi-tap method, and access the Admin Menu for advanced configuration. ...

    • Ingenico Lane/3000 - Device Restarting Unexpectedly

      Article Contents: This article explains how to correct the issue of a device unexpectedly restarting during the day, which is commonly caused by inaccurate time settings. It provides a step-by-step guide to updating your time settings on the ...

    • Ingenico IPP-320 - Blank Message or Not Connected

      Article Contents:- This article summarizes resolution steps to address a disconnected Ingenico IPP320 card reader. Note:- Follow these step after the Ingenico credit card reader is plugged into the system and after all drivers and mSDK services have ...

    • Ingenico Lane/3000 Time Setting

      Article Contents: To adjust the date and time in the Lane/3000 settings you will need to navigate the admin menu for the device by following the below instructions. Step By Step Guide: Step 1: Accessing and Navigating the Admin Menu. - The Admin Menu ...

    • Ingenico Lane/3000 - Restarting The Device

      Step 1: You can restart your terminal using either of the following methods: To perform a soft reboot, Access the Admin Menu and select the Restart Terminal option. To perform a hard reboot, press and hold the .,#* key and < (yellow key) ...